diy

DIY Antique Bench

DIY Antique Bench | helloallisonblog.com

I built a DIY antique bench for our entryway that I shared in our Fall Entry Tour earlier this week and today I’m giving all the details so you can make one too!

 

DIY Antique Bench | helloallisonblog.com

 

 

DIY ANTIQUE BENCH

 

SUPPLIES:

 

  • 2x8x8 or scrap wood
  • miter saw
  • measuring tape
  • kreg jig, screws or large heavy duty nails
  • sander
  • stain or paint

 

STEPS:

 

DIY Antique Bench | helloallisonblog.com

 

  1. Measure and cut your board to desired height and length. I used wood from our lumber pile, so I cut mine to 48″ in length and the legs at 16″ high. With the miter saw, cut legs at 15 degree angle. There is no need to flip the wood, just move it over and make your next cut.
  2. Layout your seat and legs deciding where you would like the legs to be. I did mine 10″ inward on both sides. Of course, if your bench is smaller or larger than 48″ adjust the placement accordingly.
  3. At this point, how you attach the legs is up to you. Using a keg jig is probably best. Or drill pilot holes and use large screws. However, I was on a time crunch so Joe used heavy duty nails & a hammer and nailed the legs in from the top. We’ve used this method before, like in our DIY Sofa Table. Disclaimer: this is not a bench anyone will be sitting on, if you plan to sit the Keg Jig would be best. 
  4. Sand and stain bench how you like. Ours was perfectly weathered from being outside, so I just sanded it down.

 

DIY Antique Bench | helloallisonblog.com

 

DIY Antique Bench | helloallisonblog.com

 

What do you think? Is this a project you’ll be making? Share with me!

Leave a comment or chat with me on Instagram + Facebook!

 

LIKE THIS DIY ANTIQUE BENCH? PIN IT & SAVE FOR LATER!

 

DIY Antique Bench | helloallisonblog.com

 

You Might Also Like

previous
next

2 Comment

  1. Reply
    The Furnshop
    September 21, 2017 at 11:15 pm

    This bench looks pretty. It’s an amazing tutorial.

    1. Reply
      Allison
      September 26, 2017 at 7:21 pm

      Thank you!

Leave a Reply