(post contains affiliate links, see disclosure)
DIY ANTIQUE BENCH
- 2x8x8 or scrap wood
- miter saw
- measuring tape
- kreg jig, screws or large heavy duty nails
- stain or paint
- Measure and cut your board to desired height and length. I used wood from our lumber pile, so I cut mine to 48″ in length and the legs at 16″ high. With the miter saw, cut legs at 15 degree angle. There is no need to flip the wood, just move it over and make your next cut.
- Layout your seat and legs deciding where you would like the legs to be. I did mine 10″ inward on both sides. Of course, if your bench is smaller or larger than 48″ adjust the placement accordingly.
- At this point, how you attach the legs is up to you. Using a keg jig is probably best. Or drill pilot holes and use large screws. However, I was on a time crunch so Joe used heavy duty nails & a hammer and nailed the legs in from the top. We’ve used this method before, like in our DIY Sofa Table. Disclaimer: this is not a bench anyone will be sitting on, if you plan to sit the Keg Jig would be best.
- Sand and stain bench how you like. Ours was perfectly weathered from being outside, so I just sanded it down.
What do you think? Is this a project you’ll be making? Share with me!
LIKE THIS DIY ANTIQUE BENCH? PIN IT & SAVE FOR LATER!